Lathe cutting tools should also be sharp. Safety Precautions for Lathe Machines By Megan Martin ... Read the user manual, including all safety procedures, before you start work. You should inspect your ladder each day prior to use to ensure that it is in good condition. Ensure all the guards are in place and secure before using a grinder. The Plant and Equipment Risk Management Forms and Safe Work Procedure templates have been designed as generic guides to assist workplaces with assessing plant risks and developing safe work procedures. 2. Where a safer alternative cutting tool is available or can be obtained, an Angle grinder should not be used as a cutting tool. Keep work area clean and tidy. Safety glasses must be worn at all times in work areas. Check for cracks in the rungs or side rails or any other visible defects. Ensure the appropriate disc is correctly in place. Ensure appropriate guarding is in place on grinder. GRINDER SAFETY worksafenb.ca. O:\Student Support and Training\Health and Safety\SOP's\SOP_Grinder - Angle Grinder.doc CENTRAL OFFICE USE ONLY DO NOT use this machine unless you have been trained in its safe use and operation. We are happy to share established safe work procedures with all local governments. Safe work procedures ensure your workers are aware of the issues in their work tasks, and outline how to avoid injury or illness while doing these tasks. Keep flexible electrical cords clear of oil, grease, machines and sources of heat. They must also be developed in consultation with your workplace safety and health committee or representative and be approved by management. Set up screens or shields in areas where nearby workers may be exposed to flying fragments, chips, dust, and excessive noise. Hearing protection must be used. ANGLE GRINDER (cordless) DO NOT use this machine unless a teacher has instructed you in its safe use and operation and has given permission. Hearing protection must be used when using this machine.

Always wear safety goggles or safety glasses with side shields complying with current national standards, and a full face shield when … Safety glasses must be worn at all times in work areas. Following good safety practices when using a die grinder is a must.

in its safe use and operation and have been given permission. PERSONAL PROTECTIVE EQUIPMENT. is clearly understood. available. 1 Body; 2 Videos; 3 References; 4 Categories; 5 Keywords; Body . Post warning signs where pneumatic tools are used. SAFE OPERATING PROCEDURE ANGLE GRINDER DO NOT use this equipment unless you have been instructed in its safe use and operation and given prior permission. Workers must be trained in the safe work procedures for your facility so they understand the steps and equipment they must use to work safely. Do not lift or drag angle grinders by the cord. in its safe use and operation and have been given permission.

Electric angle grinders must only be used on circuits protected by a residual current device (RCD) and/or safety switch. Drawings, instructions, specifications etc.) CSA approved footwear with substantial uppers must be worn. Hot work includes welding, flame cutting, soldering, brazing, grinding and the use of other equipment incorporating a flame, e.g. 3. The correct size grinder is selected for the job. Identify ON/OFF switch.

Long and loose hair must be contained. The correct flange and locking nut is in place for the type of disc being used.

Only persons who have been fully briefed on the safe use of angle grinders are to use these machines. …